Live SmartStorm Demonstration
For your convenience we have set up a live SmartStorm Irrigation Controller for testing and evaluation. By clicking the links below you have full access to this live unit. You can make changes to the configuration and settings through the setup pages.
The diagrams illustrate how this demonstration is wired. The valves on the SmartStorm are not connected to a load; however, you can still access and control the valves/relays by turning them on or off through the SmartStorm control page. The SmartStorm is also wired to a temperature sensor to allow you to test the shutoff setting.
The digital input state on the SmartStorm only changes when a voltage is applied to the input. For this demonstration, we have connected one of our X-332 controllers to Input 1 on the SmartStorm. You can apply a voltage to this input by accessing the control page for the X-332 (Digital Input Control Page).
**A few sprinkler programs have already been set up to demonstrate the programming flexibility.
- Multiple users may be accessing this device simultaneously so the device can change while you are using it.
- This unit will be reset to factory defaults daily at 2:30AM MST.
- Please DO NOT change network or password settings.