Expansion Bus Power Injector
DC power injector has two ribbon cable connectors and a connector for supplying 9-28V to the expansion bus separately from a X-400 or X-600M controller
Overview
The X-400 or X-600M controllers can provide up to 1.7 Amps for powering the attached expansion modules. In applications where a large number of expansion modules are used and additional current capacity is needed, a DC power injector can be employed.
The Expansion Bus Power Injector has two ribbon cable connectors and a connector for supplying power to the expansion bus separately from an X-400 or X-600M controller.
The communication signals pass-thru the power injector but the DC power from the X-400 or X-600M does not. The power injector thus provides power for all of the expansion modules to the left side of the injector. The ribbon cable itself can only carry 1.7Amps maximum. Install one or more power injectors such that no portion of the ribbon cable carries more than 1.7Amps.
Note: It is recommended to power a X-400/X-600M controller and power injectors using the same power supply.
Compatible Products
Expansion Bus Power Injector
In Stock
PART NUMBER
X-PINJECT
COMPATIBILITY
Expansion Cable for the X-600 Series
PRICE
$19.95
Quantity:
