ControlByWeb
Product Catalog   (435) 750-5999

In this video you will learn how to physically install the XW-110 Wireless Temperature Sensor with an external temperature sensor to wirelessly monitor a walk-in freezer.


Additional Resource

View the XW-110 Installation & Setup Guide for Walk-in Freezers (0.3 MB)

VIDEO TRANSCRIPT:

How to install an XW-110 to monitor a walk-in freezer

Step 1: Drill a hole in the freezer

Remember to drill through the insulation

Step 2: Install the sensor

  1. Thread the wire through the hole
  2. Seal the interior hole using a non-hardening duct seal
  3. Place sensor away from corners, vents, or doors (place in an area that best represents the freezer)
  4. Also, seal the exterior hole using a non-hardening duct seal

Step 3: Wire the external sensor to the XW-110

  1. First, remove the built-in temperature sensor
  2. Then, wire the external sensor to the XW-110

Step 4: Mount and power the XW-110

  1. Mount the XW-110 using mounting screws or an adhesive.
  2. Power using the 5V power suppy and/or batteries

Step 5: Clean up your wires

You are now ready to set up the XW-110 on your network

Next XW-110 Video:

XW-110 Setup Using DHCP & High/Low Email Alerts

In this video you will learn how to access the XW-110's setup pages, how to set it up on a network using DHCP, and how to configure it to send email alerts if the temperature exceeds a certain threshold.

Subtotal

SECURE CHECKOUT

Your cart is empty.


Your Cart is currently empty.


View Return Policy View Cart