X-17s™ | Specifications

Power Requirements

• Voltage: 9-28 VDC (supplied via the X-400 or X-600M controller, 24V recommended)
• Max Current: See table below for typical values at 25°C.

Relay Contacts

• Number of Relays: 4
• Max Voltage: 125VAC, 30VDC
• Max Current: 2.5A
• Contact Type: SPST (Form A)
• Load Type: General purpose
• Contact Resistance: < 100 milliohms initial
• Contact Material: AgSnO2
• Electrical Life: 100K operations (Min)
• Mechanical Life: 5M cycles (Min)
• Environmental Rating: Over voltage Category II, Pollution Degree 2
• Relay Modes: On/Off or Pulsed
• Pulse Timer Duration: 0.1 to 86,400 Seconds (1-day)

Digital Inputs

• Number of Inputs: 4
• Type: Optically-Isolated
• Voltage Range: 3-26VDC
• Current: 0.6mA @ 3V, 8.2mA @ 26V
• Minimum Hold Time: 2.5mS
• Input Isolation: 1500V
• Input Functions: Monitor State, Control Relays, Control Remote Relays, Count, Frequency, High Time, ON Time
• Maximum Count: 32-bit
• Max Count Rate: 200Hz
• Edge Trigger: Rising, Falling or Both
• High Time: Pulse width (4,194,304 seconds max)
• On Time: Accumulated time an input is asserted (4,194,304 seconds max)
• Frequency: 1 Hz min, 200 Hz max

Connectors

• Relays & Inputs: 14-Position, 3.81mm terminal spacing, Removable. For 16-28 AWG wire.
• Expansion Connector: Ribbon cable, 10-conductor, polarized, 2x5-position, 0.100" pitch Provides power and communications for expansion modules (Communications: RS-485)

LED Indicators

• Number of LEDs: 9
  • Power on
  • Relay coil energized 1-4
  • Digital Inputs 1-4