X-401™ | Specifications

Power Requirements

• Voltage:
  • X-401-I: 9-28 VDC
  • X-401-E: POE and/or 9-28 VDC
• Max Current: 233mA

Relay Contacts

• Number of Relays: 2
• Max Voltage: 28VAC, 24VDC
• Max Current: 3A
• Contact Type: SPDT (Form C)
• Load Type: General Purpose
• Contact Resistance: < 50 milliohms initial
• Contact Material: AgSnO2
• Electrical Life: 100K cycles (Typical)
• Mechanical Life: 10M cycles (Typical)
• Environmental Rating: Over voltage Category II, Pollution Degree 2
• Relay Modes: ON/OFF or Pulsed
• Pulse Timer Duration: 0.1 to 86,400 Seconds (1-day)

Digital Inputs

• Number of Inputs: 2
• Type: Optically-Isolated
• Voltage Range: 4-26VDC
• Current: 950uA @ 4V, 8.5mA @ 26V
• Minimum Hold Time: 20ms
• Input Functions: Monitor State, Control Relays, Control Remote Relays, Scalable Counter, On Timer, Total On Timer, Frequency
• Maximum Count: 24-bit
• Max Count Rate: 200Hz Max (Dependent on Configuration)
• Edge Trigger: Rising, Falling or Both

Real-Time Clock:

• Manual or NTP(Network Time Protocol) setup
• NTP Sync Period: Once, Daily, Weekly, On Powerup
• Auto Daylight Savings Adjustment
• Battery (capacitor) Power Backup

Capacitor Power Backup

• Backup Functions: Retain Real-Time Clock, 1 Register, 2 Counters, 2 Relay States
• Backup Duration: 2 week minimum

Network

• Type: 10/100 Base-T Ethernet Port
• Setup: Static or DHCP IP address configuration

Connectors

• Power, Outputs, and Inputs: 14-Position, 3.81mm, Removable
• Network: 8-pin RJ-45

LED Indicators

• Number of LEDs: 7
  • Power on
  • Relay coil energized 1-2
  • Digital Inputs 1-2
  • Network linked
  • Network activity